|
|
 |
|
 |
|
|
 |
|
|
|
| S T A N D A R D F E A T U R E S |
 |
|
|
- 5 HP Motor – 1800 RPM, TEFC, 230/460 volt, 3 phase
- Directional control valves separate control of forward, rapid and return travel. Plug-in electrical connectors with indicator lights
- Self-contained filtered lube system
- Position Detection – solid-state sealed DC switches with quick-change multi-pin connectors and indicator lights
- Oil level sight gauge on both sides
- Multiple spindle head drive, 1-1/16” and 1-3/8” diameter spindles
- Quick change quill and piston
- Pre-machined pads to accept optional guide bars and brackets
- Aesthetically advanced one-piece enclosure is quieter, safer, easier to clean and easily removed
- Feed rate control valve is lockable and load and temperature compensated
- Full 12” adjustable stroke flexibility
- Belts, sheaves and guards included
- Easily accommodates tool change position
- 80 DBA or less quiet operation
- Standard hydraulic operating pressure, 150 to 1000 PSI
- Advanced hydraulic system
- This product is available in Autocad or DXF format. Consult factory for additional information.
|
| O P T I O N A L E Q U I P M E N T |
|
|
|
- Peck feed
- Convertible spindle nose
- Dual feed controls
- Jump feed control
- Forward and back feed controls
- Back feed
- Reverse feed controls
- Timing belts and sheaves (low RPM)
- Air-cylinder counterbalance
- Dirty filter detection
- Broken tool detection
- Dull tool detection
- Tool change position
|
| A D I T I O N A L F A C T O R Y I N S T A L L E D O P T I O N S |
|
|
|
- Ceramic seal diameter
- Variable speed drive
- Left hand rotation
- Trabon lube block
- Guide bars and brackets
- Adjustable tool adapters
|
|
| W A R R A N T Y |
|
|
|
- Each unit is two hour cycle tested after assembly to meet our stringent requirements and is backed by the industry’s most comprehensive Two Year Parts Warranty.
|
| HFU-212 S H O R T F O R M S P E C I F I C A T I O N S |
|
|
|
| Rated Drilling Capacity Steel (SAE 1020) |
1.125 inches |
| Rated Drilling Capacity Cast Iron |
1.375 inches |
| Thrust at 860 PSI |
2,700 lbs. |
| Horsepower: Motor |
5 HP |
| Horsepower: Pump |
0.63 HP required |
| Torque |
800-in.-lbs. |
| Stroke |
12 inches |
| Spindle Speed |
330 to 3000 RPM |
| Feed Rate (adjustable) |
2 to 120 IPM |
| Rapid Traverse |
120 to 800 IPM |
| Depth Control (Positive Stop) |
Full 12" adjustment |
| Spindle Concentricity |
0.0005" T.I.F. |
| Depth Repeatability |
+/-0.0005"
|
| D I M E N S I O N D R A W I N G |
|
|
|
|
|
